I believe that many people use 304 Stainless Steel Glass Clamps at home or in
some buildings. What is the correct installation method for glass clips? The
following answers may help you.
304 Stainless Steel Glass Clamps
1. Positioning and paying off
The glass door is assembled by fixed glass and movable glass door leaf, and the positioning of the wire is unified. According to the design and construction drawing requirements, the positioning line of the glass door is released, and the position of the door frame is determined.
2. The limit slot at the top of the mounting frame
The width of the limiting groove should be greater than the thickness of the glass by two to four millimeters and the depth of the groove is ten to twenty millimeters. During the installation, the two metal decorative board edges are drawn from the bottom line, and then the edge of the door frame is installed by the edge line, and the groove depth in the notch is adjusted by the glue pad.
3. The installation of metal veneer
Fix the square wood on the ground and stick the metal veneer to the wood with a universal glue. If an aluminum alloy square tube is used, it can be fixed to the frame column with aluminum angles or fixed with wood screws on the wooden bricks buried in the ground.
4. Install the vertical door frame
The center line of the bullet is nailed to the door frame, and then the shape and position of the door frame column are determined by plywood, and finally the metal decorative surface is outsourced. When facing the veneer, place the head-to-head seam position on the side door of the mounting glass.