The first thing to do is to make sure that the Mirror Stainless steel Floor Spring door is fitted with a solid door frame (or aluminum frame) or with a glass clip (with a glass top clip, or a glass clip, or a glass side clip).
1. With the physical door frame fittings: Open the door to the positioning angle of 90 degrees, use the things to pad the handle to open the lower corner of the door end, one person holds the door, and the other person uses a screwdriver to adjust the accessory screws on the top of the door, and the screw is lowered downwards. The shaft of the accessory will be retracted and the door can be removed by adjusting it to a certain height.
2, With 304 Stainless Steel Glass Clamp: take the glass upper clip on the door and the stainless steel cover of the lower clip, open the door to a 90 degree positioning angle, use the thing to pad the handle to open the lower corner of the door, one person holds the door, another The person uses a 6-point spoon to unscrew the screw of the fixed bushing on the upper and lower door clamps of the door, and remove the bushing to take the door down. If you only remove the door clamp sleeve of the door and tilt the door to a certain angle, you can lift the door up a bit when the position is sufficient, so that you do not need to remove the lower door clamp sleeve of the door. The above instructions hope to help you.